Silvercrest SDS 3000 A1, Руководство по эксплуатации

Страница: 8 / 60

6
SDS 3000 A1
GB
Securing devices
NOTICE
This tripod is equipped with a quick release plate ►
2
. When a device is
screwed onto the quick release plate
2
you can, by sliding the locking
device
8
on the side of the tripod plate
3
, loosen the device together
with the quick release plate
2
from the tripod plate
3
. Thus, you do not
always have to unscrew the device from the thread
1
.
Remove the quick release plate 1)
2
from the tripod. For this, slide the locking
device
8
to the side so that you can lift the quick release plate
2
.
Screw the required device onto the quick release plate 2)
2
. To do this, turn
the screw - with the help of the handle on the underside of the quick release
plate
2
- until the device is fi rmly seated.
To replace the quick release plate 3)
2
complete with the device back on
the tripod plate
3
, slide the locking device
8
to the side and reposition
the quick release plate
2
. Then secure the locking device
8
, such that the
quick release plate
2
is fi rmly seated.
Using the tripod
When you have set the tripod up and the device is mounted on it, you can then
adjust it as follows:
WARNING - PROPERTY DAMAGE!
Always hold the grip ►
0
fi rmly when you loosen the locking screw “High”
7
and turn the crank
q
. Otherwise – if the locking screw “High”
7
is
loosened and the crank
q
is not fi rmly held - the rod with the attached
device could fall down to the lowest setting and, through it, the device
could be damaged.
Loosen the locking screw “High” ■
7
to a point where the crank
q
can be
turned easily. Turn the crank
q
to adjust the height. When the desired height
has been reached, fi rmly retighten the locking screw “High”
7
.
To swivel the device horizontally through up to 360°, loosen the locking ■
screw "360°"
5
. Take hold of the grip
0
and swivel the tripod plate
3
.
When you have reached the desired position, retighten the locking screw
"360°"
5
fi rmly.
To adjust the tilt angle, rotate the grip ■
0
and move it either up or down.
When the desired tilt angle has been reached, rotate the grip
0
again until
it is fi rm.
IB_71271_SDS3000A1_LB4.indb Abs3:6 IB_71271_SDS3000A1_LB4.indb Abs3:6 12.10.2011 9:31:37 Uhr 12.10.2011 9:31:37 Uhr