Silvercrest mp10, Инструкция пользователя, Страница: 9 / 24

SilverCrest MP10 English
7
Installing the hardware
After you have inserted the rechargeable batteries the optical sensor (2) on
the underside of the wireless mouse lights up.
1. Plug the USB connector of the charger unit into a USB port on your
switched on computer. The operating system automatically recognises the
new hardware and installs the required drivers.
2. During this short, one-off, procedure a message appears first "New
hardware found", followed by the message "The new hardware has been
installed and can now be used." After you have connected the USB the
receiver indicator light (7) on the charger unit lights up.
The wireless mouse is connected to the charger unit by means of radio
transmissions. The radio channel must be synchronized the first time you use
it. The wireless mouse and charger unit must be maximum 50cm apart for this
procedure.
3. Please press the synchronizer button (8) on the charger unit to start one-
off and automatic radio synchronization between the charger unit and the
wireless mouse. The receiver indicator light (7) flashes quickly.
4. Then press the synchronizer button (3) on the wireless mouse within 20
seconds. The receiver indicator light (7) on the charger unit soon
continues to flash with a fast rhythm. When the synchronization is finished
the receiver indicator light (7) flashes with a slower rhythm.
Synchronization is finished.
If the mouse is now used the receiver indicator light (7) flashes quickly. If not,
please repeat steps 3 to 4.
If you remove or replace the rechargeable batteries you must repeat the
synchronization. Do this by following steps 3 to 4.