Silvercrest KH 1159, Руководство по эксплуатации

Страница: 7 / 49

- 5 -
Setting the Timer
The timer can be used in both a clock and a weighing
mode.
Der Timer enables you to set the clock for a specific
period of time, at the end of which a signal tone sounds.
The preset time runs as in a countdown.
➩
Press the T-SET button
r
once. In the display
w
the bell symbol appears in the above-left.
You can adjust the time accurately to the second.
If you hold down the
▲
Z/T
y
or the
▼
UNIT
t
buttons, the time-indicators run through faster.
➩
Using the
▲
Z/T y or the
▼
UNIT t button,
programme in the desired ten-minute setting.
➩
Press the T-SET button r once. Using the
▲
Z/T y
or the
▼
UNIT t button, programme in the des-
ired one-minute setting.
➩
Press the T-SET button r once. Using the
▲
Z/T y
or the
▼
UNIT
t
button, programme in the des-
ired ten-second setting.
➩
Press the T-SET button
r
once. Using the
▲
Z/T
y
or the
▼
UNIT
t
button, programme in the desired
one-second setting.
➩
Press the T-SET button
r
to start the countdown.
You can reset the timer.
➩
Press the T-SET button r to re-set the timer.
As soon as the programmed time has expired, an
acoustic signal sounds. This signal can be switched
off by pressing on any button.
Temperature Display
When the scale is switched on, the display
w
shows the temperature in °C at the top right.
Switching the weighing function off
If you do not weigh anything for ca. 2 minutes the
scale automatically switches into the clock mode.
➩
To manually switch over to the clock mode, press
the button ON/OFF
u
.
➩
When you no longer require the scales, fold the
glass plate
i
back upwards.
Troubleshooting
➩
If the display w indicates "Err", the scale is over-
burdened. Remove material from the scale.
Never place more than 4 kg on the scale.
➩
If the display w briefly indicates "Err" and the
weighing mode cannot be switched on, the scale
is overburdened. Remove material from the scale
and then switch the scale back on again.
Place less than 4 kg on the scale.
➩
If the display
w
indicates "Lo", the batteries are
depleted. Replace the batteries.
The indicator "Lo" only appears in the weighing
mode.
➩
If „- - - -“ appears in the display
w
, wait a few
seconds.
➩
If your scale does not function as expected, replace
the batteries. Should the malfunction not be
eliminated with these steps please make contact
with our Service Centre (see "Warranty and
Service“).
IB_KH1159_E30067_LB4 20.04.2009 9:53 Uhr Seite 5