Silvercrest COCOON 1400, Руководство пользователя

Страница: 10 / 44

8
Installation Cocoon 1400
• The handset can cause an unpleasant humming noise in hearing aids, therefore keep a
sufficient distance away from hearing aids.
Possible damage:
Caution
Possible damage to the device!
Please observe the instructions in this user guide.
• Use only the power supply plug supplied. Do not use other power supply plugs, as this
may damage the rechargeable batteries.
• The wall outlet for the power supply plug must be close and easy accessible.
• Only use the rechargeable batteries supplied. Only replace the rechargeable batteries
with the same type. Insert the batteries with correct polarity (polarity is marked in the
battery compartment in the handset). Never use ordinary disposable batteries.
Important
As this telephone cannot be used in the event of a power cut, you
should use a telephone that is not connected to the mains for
emergency calls, e.g. a mobile phone.
1.7 Instructions on low radiation operation
This cordless telephone (complying with the DECT standard) allows low-radiation operation
(ECO mode).
The handset reduces its transmitting power according to the distance from the base unit
while you are making a call. The handset reduces its radio output to a minimum if you are not
making a call.
The device also supports low radiation operation with the base unit reducing its radio output
to zero after 30 seconds in standby.
This does not mean that the normal DECT radiation is harmful to health, but that low radiation
operation avoids unnecessary radiation exposure. Set the base up in a place where you do
not spend a lot of time, in the hall, for example. Do not set the base unit up in children's
rooms, bedrooms or the living room.
2 Installation
Caution
Take note of the safety instructions regarding the environment and
circumstances of the device's location and installation. Do not use in
potentially explosive environments.
Important
You must make sure that the batteries are charged before you use
the telephone for the first time. The device will not work at its best if
you do not do this.
2.1 Setting up the base unit
Carry out the following steps:
1. Plug the power supply plug into a 230 V socket. Plug the connector into the connector
socket on the underside of the base unit.