9
GB/IE
Always replace both batteries. Use only batteries of the
same type.
When inserting the battery, ensure the correct polarity!
This is shown in the battery compartment.
If necessary, clean the batteries and device contacts before
inserting the batteries.
Remove spent batteries immediately from the device. There
is an increased danger of leaks!
Batteries must not be disposed of in the normal domestic
waste!
Every consumer is legally obliged to dispose of batteries
in the proper manner!
Keep batteries away from children; do not throw them in
the fire, short-circuit them or take them apart.
If the above instructions are not complied with, the batteries
may discharge themselves beyond their end voltage. There
is then a danger of leaking. If the batteries have leaked
inside your device, you should remove them immediately
in order to prevent damage to the device!
Avoid contact with the skin, eyes and mucous membranes.
Any parts of the body coming into contact with battery
acid should be rinsed off with copious amounts of water
and / or a doctor contacted if necessary!
Preparing the product for use
Remove the insulation strip from the battery compartment
4
.
Replacing the batteries (Fig. B)
Open the battery compartment
4
on the back of the scale.
Remove the used batteries, if present.
Insert 2 x 1.5 V AAA batteries into the battery compart-
ment
4
.
Note:
Make sure you fit the batteries the right way round
(polarity). The correct polarity is shown inside the battery
compartment
4
.
Close the battery compartment
4
.
Setting the time (Fig. A)
After you have inserted the batteries, the scale switches auto-
matically into the time mode
5
. As soon as the scale has
switched into the time mode
5
, the hour value flashes in the
LC display
1
. In this event, skip the next two steps.
If the scale is in the weighing mode, press and keep pressed
the MODE button
3
for approx. 2 seconds to switch into
the time mode
5
.
Press and keep pressed the TARE button
2
for approx.
3 seconds to set the time.
Press the MODE button
3
to set the desired hour value.
Press and keep pressed the MODE button
3
to speed up
the value-setting process.
Press the TARE button
2
to confirm your setting. Then the
minute value flashes.
Press the MODE button
3
to set the desired minute value.
Press and keep pressed the MODE button
3
to speed up
the value-setting process.
Press the TARE button
2
to confirm your setting.
Note:
If you do not press another button within 60 seconds,
the set value stops to flash and the time is set.
91522_silv_Kuechenwaage_Content_GB_FI_SE_DK.indd 9
06.06.13 12:28
