Silvercrest 384782 2107, Инструкции по эксплуатации и безопасности

Страница: 11 / 15

10 GB/IE/NI
˜
Before use
˜
Unpacking
Remove the packaging . Check if the product is
damaged .
˜
Assembly
Accessory needed: Cross head screwdriver
Number of persons needed for assembly: 1 adult
Fig. Step
C
1 . Remove the knurled screw
[ 14]
from the
pole on the motor unit
[ 9]
.
2 . Place the pole on the base
[ 13]
.
3 . Fasten with the knurled screw
[ 14]
.
D
Remove the 4 lock screws
[ 15]
from the motor
unit
[ 9]
.
E
1 . Align the rear grille handle
[ 5]
upwards
and to the rear . Attach the rear grille
[ 4]
to the motor unit
[ 9]
.
2 . Tighten with the 4 lock screws
[ 15]
.
F
1 . Place the blade
[ 2]
on the motor shaft
[ 6]
.
Insert the pins on the motor shaft into the
groove
[ 3]
on the rear of the blade .
2 . Tighten the lock cap
[ 1]
on the motor shaft
[ 6]
(direction of rotation: ) .
Fig. Step
G
1 . Remove the lock screw and the lock
nut
[ 17]
from the front grille
[ 18]
.
2 . Loosen the grille clips
[ 16]
from the front
grille
[ 18]
.
3 . Centre the hanging device
[ 19]
of the front
grille
[ 18]
on the rear grille
[ 4]
.
NOTE: The 4 grille clips
[ 16]
must fit over
the frame of the rear grille
[ 4]
and the
front grille
[ 18]
.
H
Insert and fasten the lock screw and the lock
nut
[ 17]
. Close the 4 grille clips
[ 16]
over the
frame of the rear grille
[ 4]
and the front grille
[ 18]
.
NOTE: The lock screw and the lock
nut
[ 17]
are very small . Do not lose or drop
these fasteners .
˜
Tilt adjustment
Loosen the knob
[ 12]
.
Adjust the tilt angle manually .
Tighten the knob
[ 12]
again .
Do not perform the tilt adjustment when the
product is in operation .