Silvercrest 359922 2101, Руководство по эксплуатации

Страница: 13 / 131

SHSS 18 B1 ■ 10
│
GB
│
IE
Emptying the dirt container and
cleaning the filter
NOTE
► To achieve the best results, empty the dirt
container
7
and clean the HEPA filter
5
regularly.
► If you need a new HEPA filter
5
, please
contact our customer service department
(see section
Ordering replacement parts ).
1) To open the dirt container
7
, remove the
hand element
3
from the hand element
recess
e
.
2) Press the release button
4
and, at the
same time, pull the dirt container
7
forwards
and off.
3) Start by pulling the HEPA filter
5
and then
the coarse filter
6
out of the dirt container
7
(Fig. 4). Tap out both parts over a rubbish bin
or similar. If necessary, you can rinse out the
HEPA filter
5
with fresh water. Allow it to air
dry fully afterwards.
Fig. 4
4) Empty the dirt container
7
into the rubbish
bin or similar.
5) First re-insert the coarse filter
6
and then the
dry HEPA filter
5
.
6) Replace the dirt container
7
onto the hand
element
3
by first pushing the lower catch on
the hand element
3
into the recess on the dirt
container
7
. Then, press the upper part of the
dirt container
7
onto the hand element
3
until the dirt container
7
clicks into place
and sits firmly.
Cleaning the appliance
Wipe the appliance with a damp cloth. For stub-
born dirt, add a little mild detergent to the cloth. En-
sure that the appliance is completely dry before
using it again.
Cleaning the rotary brush
The rotary brush
r
should be checked regularly
for blockages; any hair, threads or dirt should be
removed. Remove the rotary brush
r
as follows:
1) Turn the floor nozzle upside down.
2) Push the catch on the cover plate towards
the symbol and remove the cover plate
(Fig. 5).
3) Remove the rotary brush
r
.
4) Remove any dirt (on both sides of the brush
bristles) and clean the rotary brush
r
.
To do this, take a damp cloth and wipe the
individual bristle bundles from the inside to
the outside.
5) To replace the rotary brush
r
, first push the
broad end onto the drive shaft so that the
rotary brush
r
hooks into place.
6) Then, push the other end into the mount so
that the rotary brush
r
sits straight in the floor
nozzle.
7) Reattach the cover plate until it clicks firmly into
place. The cover plate locks automatically as
the latch moves towards the symbol (Fig. 5).
Fig. 5