Silvercrest 344218 1910, Инструкции по эксплуатации и безопасности

Страница: 42 / 160

42 GB/IE
will be cancelled after about
10 seconds. The timer will start
counting down the remaining time
and the product will turn off au-
tomatically when the time is up.
To cancel the timer function, press
the TIMER button
22
once.
Adjusting the air flow
You can adjust the air flow man-
ually by moving the ventilation
slots
2
on the front air outlet
3
up or down.
Draining the water tank
The integrated water tank fills
with water in the following
situations:
– At low room temperature and high
humidity, the product may not be
able to evaporate the moisture
quickly enough. If this is the case,
water collects in the water tank.
– If the product is in dehumidification
mode, it draws moisture from the
air in the room. Consequently,
water accumulates in the water
tank. When the water tank is full,
the water tank indicator (
W.F )
17
lights up and the error code “E2“
is shown on the display
20
. The
product stops operating.
Proceed as follows to drain
the water tank:
Switch off the product and
remove the mains plug
10
from
the socket.
Pull the hose connector
15
off the
back air outlet
7
and remove
the hot air outlet hose
13
from
the product.
Take the product to a place where
water can drain properly.
Pull the drain plug
8
(as well
as the inner plug beneath it) out
of the opening and allow the
water to drain (see fig. I).
Insert both drain plugs
8
back
into the opening properly. Once
the product has been connected
to the power supply and the hot
air outlet hose
13
has been reat-
tached, it can resume operation.
Using continuous
water drainage
If the product is mainly being used
in dehumidification mode, it is pos-
sible to drain the water continuously
and thus empty the water tank au-
tomatically.
Switch off the product and remove
the mains plug
10
from the socket.
Pull the drain plug
8
(as well
as the inner plug beneath it) out