Silvercrest 292161, Руководство по эксплуатации

Страница: 30 / 117

■ 26
│ GB
│
IE
SKV 1200 B2
■ Now you can clean all the parts (blender jug
C
,
blade holder
A
the blade
z
and sealing ring
B
)
in warm water with a little washing up liquid
using a washing up brush . Afterwards, rinse all
the parts with clean water so that no detergent
residues remain .
NOtE
► The blender jug
C
and the measuring cup
e
are dishwasher-safe .
If you clean components in the dishwasher,
please ensure that no plastic parts can get
jammed or caught anywhere . This may cause
them to become deformed . We recommend
using the top rack of the dishwasher and a
washing programme with max . 45°C .
■ After cleaning, reassemble the blender:
–
Push the sealing ring
B
back into the recess
on the blade holder
A
with the blade
z
.
–
Place the blade holder
A
with the blade
z
back into the blender jug
C
so that the
blade
z
protrudes into the blender jug
C
.
Note the corresponding slots on the blender
jug
C
.
–
Turn the blade holder
A
clockwise as far
as possible so that the blade holder
A
sits
firmly on the blender jug
C
again .
–
Press the blender lid
r
with the measuring
cup
e
slightly offset firmly back onto the
blender
t
. Close the blender lid
r
by
turning it clockwise as far as the stop back
into the catch on the blender
t
. Ensure
that the pouring spout on the blender
t
is
closed .
In most cases, you can achieve sufficiently hygienic
cleaning of the blender
t
immediately after use in
the following way:
1) Put some water containing a little detergent
into the fully assembled blender
t
.
2) Press the blender lid
r
with the measuring cup
e
slightly offset firmly onto the blender
t
.
Close the blender lid
r
by turning it clockwise
as far as the stop back into the catch on the
blender
t
. Ensure that the pouring spout on
the blender
t
is closed .
3) Switch on the blender
t
for a few seconds .
4) Pour out the washing water . Any residues can
be removed with a washing-up brush .
5) Then rinse out the blender
t
with plenty of
clean water so that all detergent residues are
removed .
Storage
■ Store the cleaned appliance in a clean, dust-free
and dry location .
Troubleshooting
If the appliance suddenly stops working:
■ The appliance has overheated and triggered the
automatic safety cut-out .
– Turn the rotary switch
3
to 0 .
–
Remove the plug from the wall socket .
–
Allow the appliance to cool for 15 minutes .
–
If the appliance has not yet cooled off com-
pletely after 15 minutes, it will not start .
– Wait a further 15 minutes and try switching
on again .
If the appliance cannot be switched on:
–
Check that the plug is correctly connected
to a wall socket .
–
Check whether the swivel arm
1
is in the
wcorrect position .
IB_292161_SKV1200B2_LB8.indb 26 22.09.17 07:53