Silvercrest 285970, Инструкции по эксплуатации и безопасности

Страница: 22 / 52

23 GB/IE
Initial use / Use
Adjusting the time
The value (0:00) appears on the LC display
1
af-
ter the insulation strip has been removed from the
batteries.
If you would like to adjust the time during normal
operation, press the SET button
8
for 3 seconds.
The hour display will flash.
Press the button
5
or the button
7
to
adjust the hour.
Press the SET button
8
to confirm your entry.
The minute display will flash.
Press the button
5
or the button
7
to
adjust the minutes.
Press the SET button
8
to confirm your entry.
Adjusting the unit of weight
Note: The factory default setting for the scales as
supplied is “kg”. If you would like to change to „lb“
or „st“ proceed as follows:
Press the SET button
8
until you reach the
„0.0 kg“ display.
Then, press the SET button
8
for 3 seconds.
The kg unit will begin to flash.
By pressing the button
5
within 2 seconds,
you can select the desired unit of weight.
Note: If you select the „lb/st“ unit of weight, the
height will be displayed in „feet/inches.“ If you
select the „kg“ unit of weight, the height will be
displayed in „cm“.
Use
Switching on your
scales / measuring your weight
Tip: Weigh yourself at the same time of day (pref-
erably in the morning) after visiting the toilet, with
an empty stomach and without clothing to ensure
that your results are comparable.
Place the scales down on a solid, flat, horizon-
tal surface.
Note: Do not place the scales on a carpet, as
this may influence the results. If necessary you
can place a board on the carpet and place the
scales upon this. A solid floor covering is required
in order to achieve correct weight measure-
ments.
You can attach the hand-held unit
4
to the
scales (see Fig. A) or have the option of
holding it in your hand (see Fig. B).
Optionally: You can also hang the hand-
held unit
4
on a nail or screw using the slot
11
on the reverse side and therefore hang it to
the wall.
Important! The scales work via infrared
transmission. You must therefore ensure that
there is a direct connection between the infra-
red transmitter
2
on the scales and the infra-
red receiver
9
on the hand-held unit
4
.
There should be no obstacles between the
scales and the hand-held unit
4
. The infrared
transmitter
2
and the infrared receiver
9
should also not be covered.
Note: There is a limited range between the in-
frared transmitter
2
and the infrared receiver
9
(max. 1.80 m vertically).
Distribute weight evenly on both legs when you
step onto the scales. The hour display disap-
pears.
If at all possible, stand on the same areas of
the platform each time and do not move. Mov-
ing during the weighing process can lead to
discrepancies in the results. The scales will start
to measure immediately. The measurement
result will be displayed on the LC display
1
.
When the displayed weight flashes thrice, the
measurement is complete.
Note: The scales are overloaded if the dis-
play shows “Err”. Do not exceed the maximum
load capacity of 180 kg (396 lb / 28 st).
Step off the platform. The LC display
1
will
show the time once more.
Note: Do not use the scales in the vicinity of
electromagnetic fields. This could affect the
measurement results.
Safety instructions / Initial use