Silvercrest 114408, Инструкции по эксплуатации и безопасности, Страница: 6 / 31

6 GB
Please fill the salt and pepper mill only with
peppercorns or coarse salt.
FOOD SAFE! This product does
not affect the taste and aroma prop-
erties of foodstuffs.
Safety Instructions
for Batteries
Remove the batteries from the device if they
are not going to be used for a prolonged
period.
CAUTION! DANGER OF EX-
PLOSION!
The batteries must
never be recharged!
When inserting the batteries, ensure the correct
polarity! This is shown in the battery compart-
ments.
If necessary, clean the batteries and device
contacts before inserting the batteries.
Remove spent batteries immediately from the
device. There is an increased danger of leaks!
Batteries must not be disposed of in the normal
domestic waste!
Every consumer is legally obliged to dispose of
batteries in the proper manner!
Keep batteries away from children; do not
throw them in the fire, short-circuit them or take
them apart.
If the above instructions are not complied with,
the batteries may discharge themselves beyond
their end voltage. There is then a danger of
leaking. If the batteries have leaked inside your
device, you should remove them immediately in
order to prevent damage to the device!
Avoid contact with the skin, eyes and mucous
membranes. If you come into contact with cor-
rosive battery fluids, flush the affected area
thoroughly with clean water and contact a
doctor immediately.
Use
Insert Batteries / Filling of the
salt and pepper mill
Indication: The salt and pepper mill is intended
for peppercorns or coarse salt.
Proceed as follows:
1. Hold the base with the container
6
firmly and
turn the top
1
counter-clockwise (see Fig. A)
until the arrow on the top
1
is aligned with
the symbol on the base with container
6
.
2. Open the bayonet cap by turning and then
pulling it. The remove the top part
1
from the
base with container
6
.
3. Pull the motor
3
carefully off the base with
container
6
.
4. Insert 6 new batteries type AAA 1.5 V
(LR03).
Indication: Pay attention to the right polarity.
This is shown in the battery compartment.
5. Fill up the base with container
6
with pepper-
corns or coarse salt. The best result will be
achieved when filling the base with container
6
up to 75 %.
6. Put the motor
3
back on the base with contai-
ner
6
. Be sure to place the notch on the motor
marked with a white arrow into the respective
protrusion on the base with container (see Fig. B).
Indication: Please make sure that the con-
tacts
4
,
5
face each other (see fig. A).
7. Put the top
1
back on the base with con-
tainer
6
.
8. Hold the base with container
6
firmly and
turn the top
1
clockwise (see Fig. B) until the
arrow on the top
1
aligns with the symbol
on the base with container
6
.
Using of the salt
and pepper mill
Pull off the aroma seal cover
7
from the bot-
tom of the base with container
6
before use
(see fig. B).
Please keep the switch
2
pushed to activate
the salt and pepper mill. The bulb
9
on the