Silvercrest 101170, Инструкции по эксплуатации и безопасности

Страница: 18 / 25

18 GB
Safety
plug and the remote controlled
socket could be impaired and there
is a danger of over heating.
Only connect devices which are
within the stated power limit.
Do not connect appliances which
could cause fires or other damage
when switched on without supervi-
sion (e.g. an iron). Do not connect
any appliances which need an en-
gine capacitor (e.g. a refrigerator).
Do not cover the remote controlled
sockets. Heat accumulates under
the cover. There is a fire hazard.
Check the devices regularly for
damage. Do not replace damaged
parts. Contact the manufacturer or
dispose of the devices in an envi-
ronmentally responsible way.
Never touch the devices with moist
or wet hands.
In the event of malfunctions, pull
the device out of the wall socket.
Be aware that the unplugged device
is completely disconnected from the
mains only after it has been pulled
out of the mains socket.
Do not plug any heavy power cube
transformers in the remote controlled
socket as the wall sockets‘ plug
contacts may become overloaded.
To switch the remote controlled
socket not energized, remove the
remote controlled socket from the
mains.
These operating instructions are
part of the appliance. Therefore
please ensure to pass them on,
when you hand the appliance to
third parties.
Safety Instructions
for Batteries
Batteries are not intended for chil-
dren. If accidentally swallowed
seek immediate medical attention!
Never recharge non-rechargeable
batteries, short-circuit and / or open
batteries. The battery may over-
heat, ignite or explode.
Never throw batteries into fire or
water.
Do not exert mechanical loads to
batteries.
In the event of a battery leak, im-
mediately remove it from the device
to prevent damage!
Avoid contact with the skin, eyes
and mucous membranes! In the
event of contact with battery acid,
thoroughly flush the affected area
with plenty of clean water and seek
immediate medical attention!
Only use the same type of batteries.
Do not mix used and new batteries!
Avoid extreme conditions and tem-
peratures which may impact batter-
ies, e.g. on radiators.
Remove the batteries if the appli-
ance has not been used for a long
period.
Only use the specified battery
type!
Make sure you insert the batteries
the right way round (polarity)! This
is shown in the battery compartment.
If necessary, clean the battery and
device contacts before inserting the
battery!