PACKING LIST
Boat Hull with Air Deck, Oars, Foot Pump, Pressure Gauge, Wooden Seat, Docking Rope, Grab Safety
Handles, 5 Screw 1 Drain Valve, Repair Kit, Carry Bag, Bench Seat Bag and Boat Cover.
INSTALLATION TIPS
Tip 1: Make sure to tuck in wood board’s edge to the joint of tubes and bottom.
Tip 2: Make sure to press down and turn the pop-up spring valve 90 degrees before inflating. (The default
setting is for deflation.)
Tip 3: If using an electric pump, after tube inflation, use a foot pump to add a little more air to ensure
correct pressure.
Tip 4: In case the valve is loose, screw it tight with the black plastic wrench included in the accessories.
Tip 5: In case you find difficulty when installing the bench seat, put your knees on one of the inflated
tubes to add pressure to the bench handle.
HOW TO SET UP THE BOAT?
STEP ONE: STARTING UP
1. Unfold the hull
Clear a flat area (make sure it is clean and free of sharp objects). Remove the hull from box and take off
the plastic bag. Unroll the hull and lay it out flat.
2. Screw Valve Installation
1. Take off the top of the valve. (The valve
by default is at deflation position)
2. Press down the spring switch and turn it clockwise by
90 degrees. Make sure the switch is popped up.
Note: To deflate, press the inner button at the center and
turn counterclockwise 90 degrees.
3. Insert the inflation adapter to the valve.
Secure the adapter by turning it clockwise.
Connect the pressure gauge and pump to
the adapter. Start inflating until the pres-
sure reach 0.25 bar.
4. Remove the pressure gauge and pump. Put the cap on
the valve.
5