5
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping. This covering can
be readily stripped before installation. After removing this covering, wash the interior and exterior surfaces using a warm, mild soapy
water solution and a sponge or cloth, rinse with clean water and dry.
Casters
Models without a base come with Casters. To install them, tilt the unit and thread the Casters into the four Rivnuts in the bottom of the
cabinet. Make sure that they are installed tightly to prevent future thread wear. Return the unit to the upright position.
**Allow at least
two hours of off time before connecting to a power source.
Cutting Board
The Cutting Board is mounted on knobs installed on the front top surface of the cabinet.
Shelves
Inside the unit you will find Shelves and a plastic bag containing Shelf Supports. The Shelf Supports with the “tang” go on the rear
Pilasters. This shelf system allows for easy adjustment to suit your needs.
Door Adjustment and Swing
Should the Door ever require straightening, loosen the Screws on the Hinges, square the Door with the cabinet and retighten the Screws.
The mounting of the Door is easily reversible on single door units should space or convenience require that you do so. Simply remove
the Screws holding the Hinges, rotate the Door 180 degrees and relocate the Hinges on the side opposite their original location.
Location
When locating your new refrigerator, convenience and accessibility are important considerations, but the following installation guidelines
must be followed;
*Always avoid placing the refrigerator adjacent to an oven, heating element or hot air source that would affect the operation of the unit.
*For proper ventilation the bottom front of the unit must not be obstructed. The unit must be on legs or casters to raise it off the floor.
The unit can be installed tight on the sides and must have at least 4” of clearance in back.
*The unit must be level or tilted backwards slightly.
Climate Class Rating
Your Silver King Prep Table has a climate class 4 rating. It is designed for use in areas not exceeding 30°C (86°F).
