TRUCK MIXER DB 3000/4000/4500 HYDROSTATIC
GB
User Manual Rel. 4 of 11/07/18
Page 6 of 20
health. Carefully read the instructions of the product used. They can also modify the quality of the painting of the truck
mixer and damage its hydraulic parts, then use carefully.
5.4
Preparations before use.
Use protective gloves when preparing and putting into use.
Check levels of engine oil, clutch and brake fluid, hydraulic oil. Check refuelling so as to avoid having to stop work.
Check tire pressure and their condition of use.
Clean shoes and steps from mud and grease before getting on the machine.
Be sure of perfect visibility from the driver’s seat
and that the warning labels and the various accident prevention devices are clearly visible. Wear ear protections.
5.5
Safety first.
All machines can be dangerous. When a truck mixer is properly used and maintained, it is an
extremely safe machine.
If the machine is used incorrectly, it can be rather dangerous. Both in this manual and on the machine you will find the
warnings, indicating all the potential dangers and how to avoid them. If you have any doubts, ask your dealer or your direct
manager for explanations. Do not work with the machine until you are able to control it. Do not start any work until you are
certain of your and other’s safety. You may run into accidents if you perform unfamiliar operations without prior testing, which
must be carried out in free areas, away from other people and on level ground.
Follow the safety instructions shown in chapter 4.3 SAFETY PRECAUTIONS.
5.6
Putting into operation
Before putting the machine into operation, especially the very first time, or
when it is installed on a new work place, carry out the following preliminary checks and keep in mind the following
technical warnings and tips: - Check oil level;
- Check tire pressure and condition of use; - Check the area of respect and the workspaces;
- Check that the protections are set correctly; - Check that the indications and warning signs are placed on the
machine and are easily visible. - Carry out a general test of all mechanical and electrical controls of the machine, so
as to check their accuracy, efficiency and operation; - Check levels of engine oil, clutch and brake fluid, and hydraulic fluid; -
Check refuelling so as to avoid having to stop work.
5.7
Training
Before using the machine, read carefully this instruction manual and understand how
to use the machine in a safe way.
6.
ADJUSTMENTS
6.1
Adjusting the machine
At first operation on the construction site, the machine does not need any
adjustments. Verify only the points defined in: 5.4 Preparations before use.
Never carry out adjustments with the machine running/operating. Follow the safety instructions shown in
chapter SAFETY PRECAUTIONS. Every single adjustment and/or modification of the safety/work parameters
set on the machine, which has not been authorised by the technical personnel of the company SILLA or
which is not stated in this instruction manual, may influence the quality of the product and injure the operator
’s health.
The company SILLA declines any responsibility for liability, performances and safety of the machine in case of
modification/alteration of the machine and of the relevant
operation/safety parameters.
6.2 Adjusting the parking brake
Brake adjustment is carried out directly on the brake lever. By turning the knob of the brake lever you can adjust by loosing or
tightening. To get a proper adjustment, the stress on the brake lever must be of 10Kg.
Avoid “playing” with the brake knob, you may modify it and when necessary it will not work properly.
6.3 Adjusting the seat
Forward-backward adjustment.
The seat can be moved back and forth to adjust the distance of the pedals: the
operator must be able to press the pedals while keeping his back resting
against the seat. To adjust the seat position, act on the indicated lever and slide
the seat in the ideal position.
Make sure that the seat is locked.
