11
This is the recommended treatment schedule that has proven to produce the best results, but you may plan your personal treatment schedule differently
and still get satisfactory results.
Note that treating the same body part more often than once in two weeks, will not improve hair removal results.
Typical maintenance with Silk’n SensEpil™ after achieving long-term hair removal:
Due to hormonal or other physiological changes dormant hair follicles may become active. Maintenance hair removal sessions with Silk’n SensEpil™ may be
required from time to time.
10. First steps with Silk’n SensEpil™
10.2. Treating with Silk’n™ SensEpil for the first time
The skin should be shaved, clean, dry and free of any powders, antiperspirants or deodorants.
5. Press the
POWER ON/STANDBY SWITCH
. The
POWER ON INDICATOR LIGHT
will turn on and a fan sound (similar to the sound of a hairdryer) will start.
6. Approximately 3.5 seconds after pressing the
POWER ON/STANDBY SWITCH
, the
READY INDICATOR LIGHT
will turn on and the device will beep. The device
sets itself to deliver the lowest energy level pulses. The device is then ready for you to trigger the first pulse.
7. If the energy level should be higher than the lowest, press the
ENERGY LEVEL SETTING BUTTONS
using the “-“ or “+” to respectively decrease or increase
the energy level, until the desired energy level is set.
ENERGY LEVEL INDICATOR LIGHTS
will coincide with the energy level setting. (See “Energy Level”
frame).
8. Apply the
APPLICATOR
firmly to the skin, making sure the skin is spread evenly and smoothly. Make sure the
APPLICATOR TIP
is in full contact with the skin.
9. Press the
PULSE BUTTON
. The device will first determine the color of your skin.
If the color of the skin is light enough for safe application, the device will flash a pulse of light onto your skin. You will see a bright flash of light and simultaneously
hear a subtle pop sound, which is a normal noise for the device. You may feel a mild sensation of warmth and tingling.
Silk’n SensEpil™ will immediately recharge for the next pulse. After 3.5 seconds the
READY INDICATOR LIGHT
will turn on again and the device will beep.
10. Remove the
APPLICATOR
TIP from the treated area of skin.
11. Move the
APPLICATOR
TIP to another area of skin.
Use the pressure marks the device just made on your skin to guide you for proper positioning of the next pulse, avoiding both gaps and overlaps between
pulses (See “Covering skin areas” frame).
12. Repeat the process starting again with Step 5.
If you see no light pulse and the
SKIN TONE WARNING INDICATOR LIGHT
blink for 3 seconds, your skin tone, measured by the
SKIN COLOR
SENSOR
, is too dark for safe application. Try using the device on a different body part or contact the Silk’n SensEpil™ support (See: “The Skin
Color Sensor” frame)
Warning: Do not treat the same area of skin more than once per hair removal session! Treating the same area of skin more than once per
session increases the likelihood of adverse effects.
10.1. Silk’n SensEpil™ Setup
1. Remove Silk’n SensEpil™
BASE UNIT, APPLICATOR
and other components from box.
2. Verify that the
DISPOSABLE LAMP CARTRIDGE
is inserted correctly into the
APPLICATOR
.
3. Plug the power cord into the Silk’n SensEpil™
BASE UNIT
socket.
4. Plug the other end of the power cord into an electrical outlet. The
STAND BY INDICATOR LIGHT
will turn on.
Your Silk’n SensEpil™ is now ready to start.
Содержание sensepil AS101028A
Страница 1: ...1 INSTRUCTIONS FOR USE ...
