FCC GUIDELINES 1
-----------------------------------------------------------------------------
WARNING: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, Uses and can radiated radio frequency energy
and if not installed and used in accordance with the instructions,"
may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cables must be used in order to comply with emission
limits.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
Bescheinigung des Herstellers/Importeurs
-----------------------------------------------------------------------------
in Ubereinstimmung mit den Bestimmungen der BMPT-AmtsblVfg
243/1991
funk-entstort ist. Der vorschriftsmaBige Betrieb mancher Gerate (z.B.
MeBsender) kann allerdings gewissen Einschrankungen unterliegen. Beach-
ten Sie deshalb die Hinweise in der Bedienungsanleitung
Dem Bundesamt fur Zulassungen in der Telekommunikation wurde das
Inver-
kehrbringen dieses Gerates angezeigt und die Berechtigung Zur Uberpru-
fung der Serie auf die Einhaltung der Bestimmungen eingeraumt.
Silitek Corporation
Model : SK-2805
-----------------------------------------------------------------------------
(1) Silitek Corp. reserves the right to make changes or improvements
in the products described in this manual without notice at any time.
(2) Silitek is a registered trademark of Silitek Corporation.
