User Guide (Version 2.2) of the
SiRad Simple® Evaluation Kit
- 13 -
3.2 Using the Control Panel (Sensor Settings)
The control panel on the left side of the WebGUI provides the controls for the user interface. It is
used to connect to the sensor, to send commands and to change the data view. The control panel
contains the sections shown in Figure 10.
Tab
Description
COM
Presets
communication options
load and save settings
System Configuration
system settings
RF Parameters
radio and frequency settings
BB Processing
baseband processing settings
Target Recognition
target recognition settings
Scene Controls
scene control options
System Info
sensor board information
Log
recently sent control frames
Figure 10: Control panel with its different tabs
3.2.1 Communication Options (COM Tab)
The standard setting ‘localhost:9090’ is for communication via the USB port, see Figure 11 (left). If
you are using WiFi, type in the IP address and the port 9090 of the sensor’s WiFi module like in
Figure 11 (right), for example, ‘192.168.4.1:9090’.
Figure 11: COM tab of the Control Panel for USB (left) and WiFi (right) communication
3.2.2 Load and Save Settings (Presets Tab)
Load predefined settings:
You can load predefined settings via the dropdown box in the ‘Presets’
tab, see Figure 12 (left). Choose a setting and press ‘Load’. The factory presets are explained
Figure 12 (right).
Setting
Description
landing mode
high accuracy: 25 mm, distance: 6.4 m,
update rate: 17.67 Hz
max accuracy
very high accuracy: 6.2 mm
, short distance: 3 m,
update rate: 11.29 Hz
max distance
low accuracy: 75.1 mm,
long distance 38.4 m,
update rate 7.96 Hz
max update rate
high accuracy: 30 mm, distance: 7.6 m,
high update rate: 31.65 Hz,
no spectrum output
standard
high accuracy: 30 mm, distance: 7.6 m,
max update rate: 12.56 Hz
Figure 12: Presets tab (left) and predefined settings (right)