CP2114-EK
Rev. 0.1
13
5.3. WM8523-EB Overview
The WM8523 evaluation board contains a pre-installed WM8523 for evaluation and preliminary software develop-
ment with the CP2114 evaluation board. Refer to Figure 8 for the locations of the various I/O connectors on the
WM8523-EB.
J1
Daughter card connector
J2
Line output connector
J3
Headphone output connector
JP2-JP10
I2S and I2C signal connectors
JP11
Voltage regulator input connector
JP12
WM8253 supply voltage header
JP13
WM8253 supply voltage connector
JP14
Headphone amplifier SHDN header
JP15
Ground header
JP16-JP20
GPIO header for SHDN control
Figure 8. WM8253 Evaluation Board with Default Shorting Blocks Installed
5.3.1. Daughter Card Connector (J1)
The J1 connector is used to connect to a CP2114 evaluation board (CP2114-EB). The WM8253-EB must be
plugged into a CP2114 evaluation board to function properly.
5.3.2. Line Output Connector (J2)
The J2 connector is used to connect powered speakers to the WM8253 evaluation board.
5.3.3. Headphone Output Connector (J3)
The J3 connector is used to connect headphones to the WM8253 evaluation board.
5.3.4. I2S/I2C Signal Connectors (JP2-JP10)
Connectors JP2 through JP10 are provided to allow access to the I2S/I2C signals between the CP2114 and
WM8253. Placing a shorting block between pins 1 and 2 will connect the CP2114 to the WM8253. Placing a
shorting block between pins 2 and 3 will connect the corresponding WM8253 pin to ground. When monitoring the
I2S signals, connect the scope probe ground lead to the adjacent ground pin.
WM8523
U1
www.silabs.com
SILICON LABS
CP2114-WM8523-EVB
J1
J3
J2
JP13
JP9
JP10
JP14
JP7
JP8
JP5
JP6
JP3
JP4
JP2
JP15
JP12
JP19
JP20
JP16
JP17
JP18
HP OUT
LINE OUT
JP11
electronic components distributor