Silicon Graphics Active Loudspeaker System, Руководство пользователя

Страница: 2 / 8

2 007-4529-001
Active Loudspeaker System User’s Guide
Installing the Speakers
This section explains how to set up your speakers. See Figure 1 while you follow these
steps.
1. Before you begin, ensure that you received all of the following components with
you shipment:
• 1 right speaker with I/O panel and control knobs
• 1 left speaker with captive input cable
• 1 10-ft. stereo input cable with 3.5-mm jack on each end
• 1 power supply transformer module with captive output cord
• 1 AC line cord with geography-specific plug
If any of these components are missing, contact your sales representative.
2. Place the right speaker on the right side of your monitor; place the left speaker on
the left side.
3. Connect the left speaker input cable to the jack labeled
Left Speaker
on the rear of
the right speaker.
4. Connect one end of the 10-ft. stereo input cable to the jack labeled
Input Signal
on the
rear of the right speaker; connect the other end of the cable to the audio output jack
on your workstation.
Note: Some workstations use an adapter to connect the speakers to a USB port. If
your workstation does not have a 3.5-mm audio output jack, you need to install the
USB digital audio converter. Refer to the documentation that ships with the
converter for more information.
5. Ensure that the knob labeled
Off/On
on the front of the right speaker is turned all the
way to the left. Then, connect the DC power input cord to the jack labeled
18.5 VDC
on the rear of the right speaker.
6. Connect the AC line cord to the power supply transformer module. Then plug the
AC line cord into an approved electrical outlet. A illuminated green LED on the
power supply transformer module indicates that power is present.
7. Ensure that the cables and cords are not stretched or pinched in their installed
positions.