Silicon Graphics 230, Руководство пользователя

Страница: 66 / 148

50 007-4263-001
2: Installation of Customer Replaceable Components
The following instructions describe how to install the I/O panel gasket:
1. The system should still be resting on its right side to facilitate the installation.
2. Locate the four retaining slots on the system’s I/O panel opening. See Figure 2-27
for the location of the retaining slots.
3. Insert the I/O gasket’s four indentations into their corresponding retaining slots on
the I/O panel opening. See Figure 2-27 for an illustration of the procedure.
4. In order to secure the I/O gasket on the chassis, each notched finger needs to be
inserted into its slot. To do so, push on the I/O gasket where each notched finger
meets with the I/O gasket until the notched finger snaps into its slot. Repeat the
procedure for the remaining notched fingers.
5. Install the system board as described in the previous section, “Replacing System
Board” on page 43.
Figure 2-27 Installing I/O Panel Gasket
Notched fingers
Retaining slots