Silicon Graphics 1200, Руководство пользователя

Страница: 34 / 62

20 007-4248-001
3: Mounting the Server in a Rack
Slide Rail Mount
This section describes how the slide rails are installed.
1. Find the two slides and mounting hardware within the shipping container. Check
Table 3-1 to make sure that you received all items necessary to complete the
installation.
2. Identify the right and left side slide rails.
3. Extend each slide out until the tab snaps into place.
4. Press the tab, and remove the slide from the rail.
5. Place the SGI 1200 server on a flat surface and attach the right and left side slide
rails. Line up the five screw holes on each side, and install five 1/4-inch (0.64 cm)
length 10-24 screws to attach each slide.
Caution: Use only the included 1/4-inch (0.64 cm) length screws. Using longer
screws will damage the power supply case.
6. Install the right and left rear mounting brackets and extenders into the rack frame.
See Figure 3-1.
Table 3-1 Rack Installation Hardware for Slide Rail Mount
Part Description Quantity
10-24 x 1/4" screws 10
10-32 x 1/4" screws (used to mount the slides to the rear mounting
brackets) 8
10-32 nuts (kepnuts) 8
Slide rails (right and left pair) 1
Rear mounting bracket extenders (right and left pair) 1
10-32 x 1/2" screws (black) 12
10-32 barnuts 4