Installation Instructions
LOCATION
The party center should be placed where the ambient temperature is between 4ºC-32°C (39°F-90°F). If the ambient
temperature is above or below this range, the performance of the unit may be affected. For example, placing your unit in
extreme cold or hot conditions may cause interior temperatures to fl uctuate. The internal temperature range of 4°C-18°C
(39°F-64°F) may not be reached.
NOTE: This unit is front breathing. Do not
block the front air vent. Blockage of the vent
will result in high operating temperatures and
system failure. (Fig. B)
Fig.B
PREPARING THE ENCLOSURE
Tools you will need:
While performing installations described in this section,
gloves and safety glasses or goggles should be worn.
Electrical Requirements:
The appliance must be connected to an individual, prop-
erly grounded electrical outlet, protected by a 15 or 20
ampere circuit breaker or time delay fuse.
•
It is recommended that you do not install the party
center into a corner (i.e. directly beside a wall). This is
to allow the door to have a greater than 90° opening
swing. A limited door swing may lead to damaging the
door gasket.
•
The rough cabinet opening must be on a level fl oor
area and at least 23 13/16” deep by 24” wide. The
opening should also have a height of at least 34 3/4”.
•
The electrical outlet may be positioned from within
either side of the adjacent cabinetry, or the rear of the
shaded area (as shown in Fig. A).
•
If the electrical outlet is located inside the adjacent
cabinetry, cut a 1-1/2” diameter hole to admit the pow-
er cord. If the cabinet wall is metal, the hole edge must
be covered with a bushing or grommet.
3
Tape measure
Carpenter square
Electric drill with hole bit
Gloves
Level
Safety goggles
Flashlight
1
1
/2” diam. hole
* If electrical out-
let is in adjacent
cabinetry.
34
3
/4” from
underside
of
countertop
to floor
Cabinets
square
and
plumb
Fig A
23 13/16”