2-3
About the PRICOM R-9100U
Users Manual RX
(Bottom)
-Ethernet Address
The Ethernet Address of the device. The last 6 digits are the product’s serial number.
- Ethernet Address 00:80:92:18:0E: 1A is noted as 008092180E1A.
- The product’s serial number is 180E1A.
NOTE
TIP
Restore the PRICOM R-9100U to factory defaults
1. Make sure that the AC adapter is not connected to the PRICOM R-9100U.
2. While pushing the push switch, connect the AC adapter to the PRICOM R-9100U. The STATUS LED
will blink once when the connection is made.
3. Continue to push the push switch for five seconds. The STATUS LED will blink again when factory
default is successfully completed. Remove your hand from the push switch.
- Do not turn off the power to the PRICOM R-9100U while it is initializing to factory default.
- When the PRICOM R-9100U is turned on again after factory default is completed, do not push
on the push switch.
(Back)
-Network Port (10BASE-T/100BASE-TX)
Connect to the network cable. In 100BASE-TX environment, use category 5.
-USB Port
Connect to the USB cable.
-Power Connector
Connect to the AC adapter.
-STATUS LED(Orange)
Flashes during data transfer.
- LINK LED(Green)
Lights when a proper network connection is established.
Right Side)
-Push Switch
By pushing this switch, you can initialize the PRICOM R-9100U to factory default.
NOTE
- The STATUS LED/LINK LED indicates the same operation as indicated by the LEDs on the top
of the PRICOM R-9100U.
