SX-809
6 - ENGLISH
LEM International S.r.l. - Corso Monte Cucco 71/A - 10141 - Turin - Italy - VAT IT10762880010 - All Rights Reserved ®
Powering On/Off
To turn on the headphones, simply move the
On/Off Switch
in the direction of the Channel
Selector
; by doing so the earcups will light up with
a color between Blue, Green or Red, according to
the position of the Channel Selector.
It is important to clarify that, in case of the WL
model (without LED), the headphones will not
light up once switched on.
Consequently, to proceed with the shutdown,
move the
On/Off Switch in the direction of the
Charging Connector
.
Channel Selection
In order to listen what is being broadcasted by
the Silentsystem ® trasnmitter, it is necessary
to select the same channel on the headphones,
using the
Channel Selector
switch (Pic. 1).
CHANNEL
RGB COLOR
1
BLUE
2
RED
3
GREEN
The heaphones are also available in a 10
Channels Version
Battery & Charging
When the built-in battery of the headset is low
(10% of the remaining charge)
the earcups will
start flashing; it is therefore recommended to
proceed with recharging of the device.
Proceed by
placing the On/Off Switch in
the direction of the Charging Connector
(Headphones Off).
The headset is recharged using the cable with
proprietary connector (Pic. 2), and
a full charge
requires about 4 hours
, while
the actual time
of use when fully charged is between 8 and 10
hours
, according to the listening volume. During
the charging phase, the LEDs on the earcups
will be switched on and red; when charging is
complete they’ll became green.
It is advisable to recharge the battery in
environments with temperatures between 10 °C
and 30 °C.
Charging in other environments may
not be as effective.
* The charging cable may also come with a single
proprietary connector; this solution depends on the
equipment rented or purchased.
Volume Adjustment
By turning the
Volume Control Wheel
(Pic. 1) it is
possible to adjust the listening volume.
Pic. 2 - Charging Cable
