Step Three
Screw the Adjuster (F) fully into the bottom of the Supporting Legs (6).
Attach the Supporting Legs (6) into the pre - drilled holes on the underside of the Centre Rail (7) using M6 x 35mm Bolt (D)
as shown in the below diagram.
Ensuring the holes along the Centre Rail (7) are facing upwards, attach to the underside of the Cross Bars (5)
using M6 x 35mm Bolt (D) and M6 Nut (E).
D
E
6
F
Note:
Once the Supporting Legs(6) are secured in place, unscrew the Adjuster (F) slightly,
ensuring there is a 5mm gap between the Adjuster (F) and hard point of the floor.
Starting at the Headboard (1), attach the Centre Plastic Holders (G) into the holes along the Centre Rail (7).
Ensuring the Wooden Slats (4) are facing curved side up, place a Side Plastic Holder (H) onto the end of the
Wooden Slats (4). Insert the other slat end into the Centre Plastic Holder (G) then push the end with the Side
Plastic Holder (H) into the pre-drilled holes along the Side Rails (3). Repeat this process for all the Wooden Slats (4).
Step Four
7
4
X 28
4
