silentgliss 5100 Autoglide, Быстрый старт

Страница: 5 / 19

1. Disconnect Power (Power off) for 10 sec.
2. LED flashes blue twice
3. Insert the cardboard spacer 10275 provided into
the glider channel behind
the overlap arm to pack out to the desired
stacking width
4. Power on
5. Pull curtain in one direction for 15 cm and then
let go
6. LED flashes 3 x blue
7. Pull curtain in other direction for 15 cm
then let go
8.
LED flashes 3 x blue
Please note your 5100 Autoglide is equipped with touch and go and manual override.
Now the limits are set it is possible to operate the curtains by simply pulling the leading edge of either
curtain 15 cm in the desired direction, the curtain will then move to the limit in that direction.
If there is a power failure it is possible to move the curtains manually to open and close without
damaging the track or motor.
However, it will mean the first movement made in either direction after the power failure will re-set the
limits to the extreme ends, here any adjusted limit position set prior to the power failure will be lost.
Therefore the adjusted position will need to be reset as per the steps above (Re-Setting limits).
Please note, unplugging the power supply means that the limits need to be re-set as above.
3. Assigning Controls to the motor
All controls are radio control so will need assigning to the motor on the track – for each system option
follow the steps below after the limits (end positions) have been set on the motor.
5100B - Base – Wall switch 10949
On the motor