BATTERY CHARGER JACK
Battery-powered Scoops are delivered with a smart
battery
charger that mounts in ordinary wall outlets. It takes
about 10
hours to charge the battery. The charger can stay
connected to
the machine for long periods of time but must be
disconnected
during play.
REMOTE STORAGE POCKET
A pocket molded into the base of the panel allows
you to keep
the remote safely in the machine when not in use.
Get in the
habit of always storing the remote in the pocket.
RESET BUTTON
If the reset button pops during play, check for
obstructions
of the propulsion wheels. Never use wet balls and
make sure
that the chute that leads balls to the propulsion wheels is always clear of balls.
REMOTE CONTROL
The 22-button remote of the STAR can control all functions
on the
machine except for checking the level of the battery and
setting ball
locations.
1. For safety, you need to press the POWER button for
two
seconds to start the machine.
2. The machine goes in sleep mode after four hours of
inactivity.
When in sleep mode, the machine can only be turned
on from the
panel.
3. The Memory function offers a STOP button (square
icon) that
allows coming out of all memories without toggling.
The Preset
and Sweep functions have similar buttons.
The remaining functions on the remote behave in the same
way as they
do on the panel.
For best results when far from the machine, raise the remote
above your
shoulder when sending a command. This also signals to
others on
court that a change is about to occur.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna; Increase the separation between
the equipment and receiver; Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult
factory for help.
Содержание Scoop SMART
Страница 6: ...SETTING UP FOR OSCILLATION...
Страница 7: ...BALL PLACEMENT...
