mitting) for the receiver to memorize the code of the transmitter.
The transmitter can be activated by pressing the test button on
the corresponding transmitter. When the receiver receives the
transmitted signal, it will memorize the code. The receiver should
activate and
fl
ash the top strobe light, and the appropriate display
icon will illuminate.
Programmed transmitter codes are retained in memory even
when the power is removed.
Erase memory:
To erase all programmed codes:
All Erase – Press and hold the program button, the Display icons
will come on for about 3 seconds, go off and then the GREEN
PHONE icon will blink 3 times. Continue to hold the program
button an additional 3 seconds until the icons scroll in a counter-
clockwise direction several times indicating all previous learned
transmitters that were stored in memory have been erased.
Release the program button and all previously learned transmitter
codes will have been successfully erased.
Battery Backup Mode:
In the event of a main power loss or failure of the wall adapter,
the Mini Receiver will automatically enter into the battery backup
mode. The Mini Receiver has been tested to provide at least 24
Hours of Battery backup operation with 15 minutes of Alerts.
Located under the top strobe lens cover is an AMBER LED. The
AMBER LED will blink once every 10 seconds, indicating Input
DC power loss to the receiver and it is operating on the back-up
battery. The AMBER LED will blink at a one second rate once the
back-up battery has reached minimum operating voltage. Operat-
ing the receiver during a low battery indication is not recommend-
ed.
IMPORTANT: The Mini Receiver will need to charge two hours for
every hour in Battery backup mode or a full 40 Hours after low
battery indication to ensure complete battery recharge.
