Silca UC 199, Руководство по эксплуатации

Страница: 24 / 107

4.4 USE OF THE AUTOMATIC CLAMP - OPTIONAL
Keys are fitted into the clamp automatically by means of a mechanical loader. The keys are positioned on their
back and automatically locked. Keys are secured by the clamp jaws, which are powered by a motor incorporated
in the clamp. This excludes any operator interference.
NOTE: never use pins with the Automatic Clamp.
ATTENTION: only for keys with cuts on 1 side and key stop. NO keys with plastic heads
(except for SWING and SILKY), no cruciform keys or keys with tip stop.
Keys cut on this clamp must be of the types described below:
TECHNICAL DATA FOR KEYS TO BE CUT
Fig. 27
Key thickness min.1,8 mm - max.2,6 mm (with jaws A or B)
min. 2,0 mm - max.2,8 mm (with jaws A + 2,0 ÷ 2,8)
Max. cutting depth: 3,9 mm (with jaws A); 2,9 mm (with jaws B)
Blade height/width: max.10 mm (with jaws A); max.9 mm (with jaws B)
Key head width: *max. 28 mm
1) Jaws A (standard) (Fig. 28)
•
Automatic Clamp (L1): with jaws A
•
Reading standard Clamp (L100): side A
2) Jaws B (provided) (Fig. 29)
•
Automatic Clamp (L1): with jaws B
•
Reading standard Clamp (L100): side B
3) Jaws A (lower) + 2,0÷2,8 (upper - provided) (Fig. 30)
•
Automatic Clamp (L1): A (lower) + 2,0÷2,8 (upper)
•
Reading standard Clamp (L100): side A
Operating Manual
UC199
Copyright Silca 2012
20