Silca TARGA 2000, Руководство по эксплуатации

Страница: 21 / 26

TARGA 2000 Operating manual - English
Copyright Silca 1999 21
Replacing the belt:
ATTENTION: Unplug the machine from the mains.
1) Remove the protective cover on the motor (M1) by removing the four screws.
2) Loosen the four screws which fix the motor to the base.
3) Raise the motor and remove the worn belt.
4) Fit the new belt.
5) Push the motor downwards until the belt tension is normal.
6) Tighten the four screws.
Fig. 20
7.3 Tracer point replacement
To replace the tracer point (I), proceed as follows (fig. 21):
ATTENTION: Unplug the machine from the mains.
1) Loosen the screw (I1).
2) Remove the worn tracer point.
3) Fit the new tracer point, pushing all the way in; ensure that the seat is clean.
4) Tighten the screw (I1).
5) Check the depth setting, as described in ch. 6, page 16.
Fig. 21
O
M
I1
I