Silca Delta 2000 MC, Руководство по эксплуатации

Страница: 15 / 23

Operating manual - English DELTA 2000 MC
Copyright Silca 1 998 11
6 REGULATION AND USE OF THE MACHINE
6.1
Checking and Setting
The cutting tool on the DELTA 2000 MC is used to cut the key blanks and must be periodically checked
and replaced.
Periodically, and whenever the cutting tool is replaced, check the key-cutting machine settings, to ensure
perfect machine efficiency.
6.2 Setting
A
XIAL SETTING
Axial setting refers to adjustment of the distance between the tracer point position and cutting position
(fig. 10-A).
The axis setting for the DELTA 2000 MC is fixed and is established on assembly in our
workshops.
Fig. 10
D
EPTH SETTING
Depth setting refers to adjustment of the alignment between the tracer point depth and the depth of the
cuts.
To regulate the depth settings, proceed as follows:
WARNING: disconnect the machine from the mains.
1) place the setting pins (provided) on the clamps (fig. 10-B).
2) raise the carriage and take towards the tracer point and cutting tool u ntil the pin on the left-hand
clamp comes into contact with the tracer point.
3) turn the cutting tool anticlockwise by hand. Take the gauging pin on the left-hand clamp up to the
tracer point and ensure that the cutting tool skims the pin on the right-hand clamp.
4) turn the right-hand clamp knob upwards and repeat the operation described above.
5) if necessary, regulate the cutting depth by means of the tracer point, as described below:
a) loosen the tracer point locking screw (G3) (fig. 11).
b) turn the adjusting nut (G2): clockwise to advance the tracer point (G), anticlockwise to move the
tracer point back.
6) when regulation is complete, screw down the screw (G3) to lock the tracer point.
7) if the height of the tracer point must be adjusted, loosen screw (G1) and re-position manually.
8) when regulation is complete, screw down the screw (G1) to lock the tracer point.
Fig. 11
setting
pins
A B
G3
G1
G2
G