Silca Crown D422143XA, Руководство по эксплуатации, Страница: 6 / 29

CROWN Operating manual - English
2 Copyright Silca 2001
GENERAL INSTRUCTIONS
The CROWN key-cutting machine has been designed according to the specifications of the Machine
Directives. From the design stage risks for the operator have been eliminated in all areas: transport,
regulation, cutting and maintenance.
The use of protective goggles is compulsory during cutting operations, as indicated on the machine
itself and in this manual.
The material used in the manufacture of this machine and the components employed during use of
the machine are not dangerous and their use complies with standards.
U
SE
The CROWN key-cutting machine must be installed and used in the way laid down by the manufacturer,
as illustrated in this manual.
If the machine is used differently or for purposes different from those described in this manual, the
customer will forego any rights he may have over SILCA S.p.A. Furthermore, unforeseen danger to the
operator or any third parties may arise from incorrect use of the machine.
Negligence in the use of the machine or failure on the part of the operator to observe the instructions
given in this manual are not covered by the guarantee and the manufacturer declines all responsibility
in such cases.
It is therefore indispensable to read the operating manual carefully in order to make the best use
of the CROWN key-cutting machine and benefit from its potential.
F
URTHER RISKS
There are no further risks arising from the use of the CROWN key-cutting machine.
P
ROTECTION AND SAFETY PRECAUTIONS FOR THE OPERATOR
The CROWN key-cutting machine is built entirely to standards. The operations for which it has been
designed are easily carried out at no risk to the operator.
The adoption of general safety precautions (use of protective goggles) and observation of the
instructions provided by the manufacturer in this manual eliminate all human error, unless deliberate.
The CROWN key-cutting machine is designed with features which make it completely safe in all its
parts.
• Power supply
The key-cutting machine must be supplied with electricity. The plug must be earthed.
• Start-up
The machine is started up:
-
by means of the START button on the safety device (standard with 230V key-cutting machines, on
request for other voltages);
- by means of the master switch.
• Operation
The machine is started up by means of a motor switch.
• Maintenance
The operations to regulate, service, repair and clean the machine have been devised in the simplest
and safest way possible. There is no danger of removable parts being replaced wrongly or unsafely.
• machine identification
The CROWN is provided with an identification label which shows the serial number (fig. 1).
Fig. 1
N˚ MATRICOLA
SERIAL No.
Telefax (0438) 913800
Telex 410579 SILCA I
SILCA S.p.A. - Via Podgora 20 (Z.I.)
31029 VITTORIO VENETO (TV) ITALY
TIPO
TYPE
VOLT
A. Hz. WATT
(0438) 9136
☎
Manufacturer’s
identity
Serial No.
Type of machine
Absorbed power
Working
frequency
Absorbed
current
Year of
manufacture
CE mark
Working
voltage
®