Siko 50010890, Перевод оригинальной инструкции по установке, Страница: 51 / 64

AG03/1
Battery change English
AG03/1 · Date 30.05.2022 · Art. No. 86426 · Mod. status 116/22
51
6.2 Operating states
Refer to the manual for more detailed information about failures and
warnings.
6.3 Changing the battery
Actuator failure ( Fig. 12 )
Improper installation of the cover
15
leads to loss of the protection class.
` The screws
14
with loss protection
21
and light guide
20
must fit cor-
rectly in the cover
15
.
` Ensure that the O-ring
16
fits correctly in the groove.
` Fibre optic cables must be seated in the holes provided in the housing.
` Make settings in the setup mode only.
18
19
16
15
14
21
20
14
Screw
15
Cover
16
O-ring
18
Battery
19
Holder
20
Light guide
21
Loss protec-
tion
Fig. 12: Changing batteries
Preparation:
1. Connect actuator to supply voltage.
2. Place the replacement battery ready (see chapter
6.1
).
3. Place a Phillips screwdriver ready (e. g . PH 1).
Dismounting (see Fig. 12 ):
1. The battery compartment is situated behind the cover of the cover
15
.
2. Remove the cover
15
incl. the plugged screws
14
with loss protection
21
and light guide
20
.
3. Use your fingernail to bend the battery slightly outward.
4. Grasp the used battery
18
at the upper edge and pull out axially.
WARNING