MAGIC SWITCH
User Manual
3
Windows installation
Please follow the instructions below to install the Magic Switch driver.
1. Connect one end of the Magic Switch to a standard USB port on one of the two computers.
And connect the other end of the Magic Switch to a USB port on the second computer.
2. The device will automatically start the Magic Switch software installation on both
computers. An
AutoPlay
option window may appear. Please double-click the Magic
Switch icon
to start the application.
3. If the
User Account Control
window appears on the screen, click
Yes
to continue.
4. Please run the steps above on both computers. If the other computer is a Mac, please refer
to the Mac installation guide.
5. When the Magic Switch is connected properly the Magic Switch launch page will be
shown.
The Magic Switch icon will appear in the lower right-hand corner. If the two units are
connected to the USB3.0 port this icon
will appear, indicating the transmission speed as
USB3.0; however, if a USB2.0 port is connected to one end, then this icon
will appear,
indicating that the transmission speed is USB2.0. If the
icon appears it means the other
computer is not connected. When this icon
appeared means the keyboard & mouse is
under controlled by other computer.
6. Please set the position of the other PC. Please click on the Magic Switch
or
icon to
open the Magic Switch toolbar. Then click on The Position of Other PC and select the
screen location according to where you want your mouse to flow from one screen to the
other.
