4
4.
Set
J1
and
J2
jumper settings to the desired voltage
only if your serial device needs additional power
from the serial port. However, most serial devices
do not require additional power. For more
information see
Jumper Settings
on page
2
. The
jumpers can be removed if power is not required. If
power output is required, connect the board's power
connector.
5.
To install the card, carefully align the card's bus
connector with the selected PCIe slot on the
motherboard. Push the board down firmly, but
gently, until it is well seated.
6.
Replace the slot bracket holding screw to secure the
card.
7.
Replace the computer cover and reconnect the power
cord.
Driver Installation
This section provides information on how to install the
CyberSerial Dual PCIe
drivers.
Windows 2000
1.
At the
Found New Hardware Wizard
, click
Next
.
2.
Select
Search for a suitable driver for my device
(recommended)
, and click
Next
.
3.
Check
Specify a location
, uncheck the other boxes,
then click
Next
.
4.
Insert the driver CD, type in
D:\2000
, then click
OK
.
(Change
D:
to match your CD-ROM drive letter)
5.
Click
Next
and
Finish
.
6.
Repeat steps
1-5
two more times.
7.
Restart Windows to complete the installation.
