4
•
RGB skew adjust (-,+)
: Push button to decrease (
-
)
or increase (
+
) skew of the color channel (R/G/B)
chosen by the
RGB selector
rotary dial
Dip Switch (Serial Mode)
The DIP switch is located on the bottom panel of the
receiving unit. See table below for description.
Notes
:
1
TxD: The 3rd pin of RS-232, which is in charge of
sending data;
2
RxD: The 2nd pin of RS-232, which is in
charge of receiving data.
Hardware Installation
1.
Power off all devices.
2.
Connect your VGA and RS-232 source to the
transmitting unit.
3.
Connect your display and RS-232 receiving device
to the receiving unit.
4.
Connect your CAT-5/5e/6 LAN cable between the
transmitting and receiving units, make sure the
cable connection is tight and not loose.
5.
Plug in the 5V DC power cord to the power jack of
transmitting and receiving units.
Dip Switch Position
Pin#1
Pin#2
Pin#3
Pin#4
Description
ON
OFF
ON
OFF
OFF
OFF
ON
ON
Master to Slave mode -
TxD of transmitter to RxD of receiver
RxD or transmitter to TxD of receiver
Tx to Rx Extender Mode -
TxD
1
of transmitter to TxD of receiver
RxD
2
of transmitter to TxD or receiver
