SIIG CE-MT2912-S1, Руководство по установке

Страница: 3 / 8

3
Installation
Caution : This projector mount must be securely attached to ceiling. If the mount is not
properly installed it may fall, resulting in possible injury and/or damage. SIIG, Inc. is NOT
RESPONSIBLE for any damage or injury caused by incorrect installation, assembly or use
Note : The mounting components and hardware supplied in this package are not designed
for installations to ceilings with steel studs. If the hardware you need for your installation is
not included, please consult your local hardware store for proper mounting hardware for the
application.
Step 1 - Installing the Tube to Ceiling
Important : Don't loosen the two side nuts at the same time after finishing the installation for
fear that the mount drops.
1. Place the Tube Support's mounting plate in the desired position on the ceiling, using the
mounting plate as a template mark 4 holes, then remove the tube support.
2. Using a 10mm drill bit drill 4 holes 50mm deep in the marked positions. Note: The holes
should be drilled symmetrical in horiziontal and vertical direction.
3. Insert four metal anchors into the drilled holes until flush with the ceiling, then tighten
the nut slightly to secure the steel anchor to the ceiling. Remove the flat washers,spring
washers and nuts from the steel anchors.
4. Place the mounting plate on the four metal anchors,and install the flat washers,spring
washers and nuts and tighten them until hand tight.
Note : Each nut should be tightened so the steel anchor and the tube support are securely
fastened to the ceiling, do not over tighten.
Figure 1
A
Ceiling
Tube