Instruction of Software Connection
1.
Power up the AV-GM0AK3-S1 and you can see both red and green LEDs on the front panel
blink. Make sure the serial port USB connection secure.
2.
The first step after running the software is to automatically detect if the device responses
correctly through USB port. The process takes 15-20 seconds. If the response is not accurate,
a warning window will show up as the figure below.
The possible reasons causing this failure could be:
The AV-GM0AK3-S1is not supplied with power or the AV-GM0AK3-S1 enters deep sleep state.
Please check the current status, and reboot the AV-GM0AK3-S1.
The serial connection through USB is not well established or some other software has taken the
available serial ports. Please make sure the USB cable is well connected and the available serial
port is free to be used by the AV-GM0AK3-S1.
Com setting is not correct. Please make sure that from Menu
→
Connector
→
Setting.
3.
If the serial connection is well established, you can see similar work window as below.
