~ 6 ~
INSTALLTION
1.
Switch off all devices, including monitors.
2.
Connect the video and audio sources to the AV-GM06R3-S1. For component video
source, please find a VGA-component breakout cable to plug into the VGA IN port.
3.
Connect the video displays and audio speakers to the receiving units BPVGARA or
BPVGARAD. For component video display, please find a VGA-component breakout
cable and plug into the VGA OUT port on the receiving units BPVGARA or
BPVGARAD.
4.
Connect a Cat-6 Shielded cable to each VGA SIGNAL OUT RJ45 port on the
AV-GM06R3-S1 and the VGA SIGNAL IN RJ45 port on each receiving unit BPVGARA
or BPVGARAD. Make sure these Cat-6 Shielded cables are tightly connected and
not loose.
5.
Plug in 5V DC power supply units and power on all devices.
6.
If you see the monitor is displaying blurred video or even worse, not displaying at
all, please adjust the EQ and Gain rotary controls on the receiving units BPVGARA
or BPVGARAD to improve the cable skew. GAIN rotary control is to adjust the gain
to an appropriate level for a range of input signal levels (brightness), and EQ rotary
control is to equalize the wave form of the receiving video signal (sharpness). It is
suggested to begin with adjusting the rotary control of EQ to get the input video
displayed first, and then the rotary control of GAIN according to the video you see
on the screen.
7.
Adjust RGB delay skew on the receiving unit BPVGARAD to get even better picture
quality for long distance transmission.
Connection Diagram
