MainView Installation Instructions
PN xxxxxxxxxxxx Rev x
4/3/2020
page 2
www.hadco.com
442295160211 Rev B
LIGHT ENGINE REPLACEMENT:
1.
TURN POWER OFF. Remove pod door using the flat screw driver. There is a safety cable connecting the door to the pod
allowing the door to hang.
2.
Disconnect the following wires from the existing light engine assembly: ground wire, driver white power wire, if future proof
receptacle is used
-
disconnect the white and black wires. If a pod photo control receptacle is being used, disconnect the
power wires. If a FAWS is being used disconnect the purple and gray wires. These wires are connected into Wago con-
nectors.
3.
Loosen the two screws that hold the light engine in place, use the phillips head screw driver. Twist light engine assembly
clockwise and lift.
4.
Lower replacement light engine assembly onto pod. Twist counter clockwise. Tighten the hold down screws using a phil-
lips screw driver.
5.
Connect al the wires from Step #2 back into the appropriate Wago connectors.
6.
Install the pod door back on to the pod and use flat screw driver and tighten captive bolt.
