Document No DCP0002129 TC 26/03/02 Rev 4
This document should be incorporated in the maintenance manual.
Do not leave with the system operator.
PDA200E Induction Loop System
Installation Guide
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE
INSTALLING AND/OR MAINTAINING THIS EQUIPMENT
These instructions are general and cannot be considered to cover every aspect of loop amplifier installation.
No responsibility can be accepted by the manufacturers or distributors of this loop amplifier for any
misinterpretation of an instruction or guidance note or for the compliance of the system as a whole.
The manufacturers policy is one of continuous improvement and we reserve the right to make changes to
product specifications at our discretion and without prior notice. E&OE
Technical Features
The PDA200E is a current mode induction loop
amplifier with the following features:
Up to 120m
2
coverage - ideal for most
applications
Straightforward internal screw connections
Ideal for electrical contractors - no audio
connectors
Wall mounted for permanent installation
Internal controls avoid user tampering
Mid-range tone control to improve intelligibility
Alert input & tone generator for door bells, fire
alarms etc.
Fully automatic compressor-limiter controls
output level
Balanced microphone and line level controls
Phantom power on microphone input for
electret microphones
100V line input from PA system
Larger coverage from smaller cable due to 2
Ω
loop drive
Complete with full instructions and ‘loop
fitted’ sticker
Contractor kits available for retail, offices,
places of worship etc.
Additional line and microphone inputs using
Outreach plates
