2
Rotunda Widespread Faucet Installation Instructions
3. Remove the protective sheath, double-wedge nut, locking washer and rubber washer from the faucet body. Repeat
the previous steps to secure the faucet body.
Faucet Body
Locking Nut
Rubber Washer
Base Plate
Protective Sheath
Double-wedge Nut
4. Hand tighten to attach the hot and cold flexible water feed tubes to the handle bodies and brass T. Give a ¼ turn with
pliers or wrench, but don’t over tighten. Curve tubes as necessary to ensure there are no kinks or knots.
5. Connect the main water supply to the faucet body.
6. To install the new pop-up drain, apply a bead of silicone sealant to the underside of the drain flange and place in the
mounting hole. If there is no pop-up drain, move on to step 16.
7. Thread the lock nut onto the drain pipe and tighten with your adjustable wrench.
8. Wipe away any excess sealant around the drain using your damp cloth.
9. Push the pop-up rod down through the faucet body. Attach the pop-up rod to the pivot rod with the extension rod.
Adjust the rods so that the drain stopper opens and closes properly.
10. Attach the P trap to the drain pipe and wall drain fitting and tighten the lock nuts.
11. When your faucet installation is complete, turn on the water supply. Check to make sure that all connections are tight
(no water should be leaking) and that the hot and cold supplies are working correctly. Turn the water on and allow the
water to flow through the spout for approximately 60 seconds.
