SignaMax SC30010, Справочное руководство CLI

Страница: 549 / 671

Chapter 21
| Multicast Filtering Commands
MLD Filtering and Throttling
– 549 –
Example
Console(config)#interface ethernet 1/1
Console(config-if)#ipv6 mld filter 19
Console(config-if)#
ipv6 mld max-groups
This command configures the maximum number of MLD groups that an
interface can join. Use the
no form to restore the default setting.
Syntax
ipv6 mld max-groups number
no ipv6 mld max-groups
number - The maximum number of multicast groups an interface
can join at the same time. (Range: 1-255)
Default Setting
255
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
◆
MLD throttling sets a maximum number of multicast groups that a port can
join at the same time. When the maximum number of groups is reached on
a port, the switch can take one of two actions; either “deny” or “replace.” If
the action is set to deny, any new MLD join reports will be dropped. If the
action is set to replace, the switch randomly removes an existing group
and replaces it with the new multicast group.
◆ MLD throttling can also be set on a trunk interface. When ports are
configured as trunk members, the trunk uses the throttling settings of the
first port member in the trunk.
◆ If the maximum number of MLD groups is set to the default value, the
running status of MLD throttling will change to false. This means that any
configuration for MLD throttling will have no effect until the maximum
number of MLD groups is configured to another value.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#ipv6 mld max-groups 10
Console(config-if)#