SignaMax SC30010, Справочное руководство CLI

Страница: 481 / 671

Chapter 19
| Class of Service Commands
Priority Commands (Layer 3 and 4)
– 481 –
Command Mode
Privileged Exec
Command Usage
This map is only used when the QoS mapping mode is set to “DSCP” by the
qos map trust-mode command, and the ingress packet type is IPv4.
Example
The ingress DSCP is composed of ingress-dscp10 (most significant digit in the
left column) and ingress-dscp1 (least significant digit in the top row (in other
words, ingress-dscp = ingress-dscp10 * 10 + ingress-dscp1); and the
corresponding dscp is shown at the intersecting cell in the table.
Console#show qos map dscp-queue interface ethernet 1/1
Information of Eth 1/1
DSCP to queue map.
d1:d2 0 1 2 3 4 5 6 7 8 9
----------------------------------------------
0 : 2 2 2 2 2 2 2 2 0 0
1 : 0 0 0 0 0 0 1 1 1 1
2 : 1 1 1 1 3 3 3 3 3 3
3 : 3 3 4 4 4 4 4 4 4 4
4 : 5 5 5 5 5 5 5 5 6 6
5 : 6 6 6 6 6 6 7 7 7 7
6 : 7 7 7 7
Console#
show qos map
trust-mode
This command shows the QoS mapping mode.
Syntax
show qos map trust-mode interface interface
interface
ethernet unit / port
unit - Unit identifier. (Range: Always 1)
port - Port number. (Range: 1-52)
Command Mode
Privileged Exec
Example
The following shows that the trust mode is set to CoS:
Console#show qos map trust-mode interface ethernet 1/5
Information of Eth 1/5
CoS Map Mode: CoS mode
Console#