SignaMax SC30010, Справочное руководство CLI

Страница: 430 / 671

Chapter 17
| Spanning Tree Commands
– 430 –
◆ When configured for manual release mode, then a link down / up event will
not release the port from the discarding state. It can only be released using
the
spanning-tree loopback-detection release command.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree loopback-detection release-mode manual
Console(config-if)#
spanning-tree
loopback-detection
trap
This command enables SNMP trap notification for Spanning Tree loopback
BPDU detections. Use the
no form to restore the default.
Syntax
[ no ] spanning-tree loopback-detection trap
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree loopback-detection trap
spanning-tree
mst cost
This command configures the path cost on a spanning instance in the Multiple
Spanning Tree. Use the
no form to restore the default auto-configuration
mode.
Syntax
spanning-tree mst instance-id cost cost
no spanning-tree mst instance-id cost
instance-id - Instance identifier of the spanning tree. (Range: 0-
4094)
cost - Path cost for an interface. (Range: 0 for auto-configuration,
1-65535 for short path cost method
****
, 1-200,000,000 for long
path cost method)
The recommended path cost range is listed in
Table 85 on
page 425 .
****.Use the spanning-tree pathcost method command to set the path cost method.