SignaMax SC30010, Справочное руководство CLI

Страница: 435 / 671

Chapter 17
| Spanning Tree Commands
– 435 –
Example
This example disables the spanning tree algorithm for port 5.
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree spanning-disabled
Console(config-if)#
spanning-tree
tc-prop-stop
This command stops the propagation of topology change notifications (TCN).
Use the
no form to allow propagation of TCN messages.
Syntax
[ no ] spanning-tree tc-prop-stop
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
When this command is enabled on an interface, topology change information
originating from the interface will still be propagated.
This command should not be used on an interface which is purposely
configured in a ring topology.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#spanning-tree tc-prop-stop
Console(config-if)#
spanning-tree
loopback-detection
release
This command manually releases a port placed in discarding state by
loopback-detection.
Syntax
spanning-tree loopback-detection release interface
interface
ethernet unit / port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-52)
port-channel channel-id (Range: 1-24)