SignaMax SC30010, Справочное руководство CLI

Страница: 380 / 671

Chapter 12
| Link Aggregation Commands
– 380 –
lacp admin-key
(Port Channel)
This command configures a port channel's LACP administration key string.
Use the
no form to restore the default setting.
Syntax
lacp admin-key key
no lacp admin-key
key - The port channel admin key is used to identify a specific link
aggregation group (LAG) during local LACP setup on this switch.
(Range: 0-65535)
Default Setting
0
Command Mode
Interface Configuration (Port Channel)
Command Usage
◆ Ports are only allowed to join the same LAG if (1) the LACP system priority
matches, (2) the LACP port admin key matches, and (3) the LACP port
channel key matches (if configured).
◆ If the port channel admin key ( lacp admin key - Port Channel) is not set
when a channel group is formed (i.e., it has the null value of 0), this key is
set to the same value as the port admin key (
lacp admin key - Ethernet
Interface) used by the interfaces that joined the group. Note that when the
LAG is no longer used, the port channel admin key is reset to 0.
◆ If the port channel admin key is set to a non-default value, the operational
key is based upon LACP PDUs received from the partner, and the channel
admin key is reset to the default value. The trunk identifier will also be
changed by this process.
Example
Console(config)#interface port-channel 1
Console(config-if)#lacp admin-key 3
Console(config-if)#
lacp timeout
This command configures the timeout to wait for the next LACP data unit
(LACPDU). Use the no form to restore the default setting.
Syntax
lacp timeout { long | short }
no lacp timeout
long - Specifies a slow timeout of 90 seconds.
short - Specifies a fast timeout of 3 seconds.