SignaMax SC30010, Справочное руководство CLI

Страница: 313 / 671

Chapter 9
| General Security Measures
Port-based Traffic Segmentation
– 313 –
◆ When traffic segmentation is disabled, all ports operate in normal
forwarding mode based on the settings specified by other functions such
as VLANs and spanning tree protocol.
◆ Enter the traffic-segmentation command without any parameters to
enable traffic segmentation. Then set the interface members for
segmented groups using the
traffic-segmentation uplink/downlink
command.
◆
Enter no traffic-segmentation to disable traffic segmentation and clear
the configuration settings for segmented groups.
Example
This example enables traffic segmentation globally on the switch.
Console(config)#traffic-segmentation
Console(config)#
traffic-segmentation
session
This command creates a traffic-segmentation client session. Use the no form
to remove a client session.
Syntax
[ no ] traffic-segmentation session session-id
session-id – Traffic segmentation session. (Range: 1-4)
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆
Use this command to create a new traffic-segmentation client session.
◆
Using the no form of this command will remove any assigned uplink or
downlink ports, restoring these interfaces to normal operating mode.
Example
Console(config)#traffic-segmentation session 1
Console(config)#
* The forwarding state for uplink-to-uplink ports is configured by the traffic-
segmentation uplink-to-uplink command.