www.signamax.com
3
Mount the Switch
Mounting in a Rack
(All models apart from SC10090, SC10100 and SC10130)
1.
Attach the brackets to the switch.
2.
Use the screws and cage nuts supplied with the
rack to secure the switch in the rack.
Caution:
Installing the switch in a rack requires
two people. One person should position the
switch in the rack, while the other secures it using
the rack screws.
Note:
The switch can also be installed on a
desktop or shelf using the included adhesive
rubber foot pads.
Ground The Switch
1.
Ensure the rack is properly grounded and in
compliance with ETSI ETS 300 253. Verify that there
is a good electrical connection to the grounding point
on the rack (no paint or isolating surface treatment).
2.
Attach a lug (not provided) to a #12 AWG (PoE
switch) or #18 AWG (non-PoE switch) minimum
grounding wire (not provided), and connect it to
the grounding point on the switch rear panel. Then
connect the other end of the wire to rack ground.
Caution:
The earth connection must not be
removed unless all supply connections have
been disconnected.
Note:
The device must be installed in a restricted
access location. It should have a separate
protective earthing terminal on the chassis.
!
!